Removal - Renkforce sd 7629 Bedienungsanleitung

• Bend down some clips in the installation frame until the frame is securely fastened in the recess.
• When you have made all the electrical contacts (see "Electric Connection") insert the SD tuner into the frame until
it locks in (fig. 4).
• Replace the frame cover of the front control panel.

Keep the two unlocking keys. You will need them for a later removal of the SD tuner.
Protect your SD tuner against vibrations with the bolt at the back of the unit.
In most vehicles, such a safety fastening is provided for. If this is not the case in your car, fasten the SD tuner with
the enclosed punched metal strip.
For the fastening, proceed as follows.

Removal

• Remove the front control panel.
• Carefully remove the plastic frame in the front of the system, by bending it slightly to the outside and pulling it off
from the unit.
• Insert the two unlocking keys into the lateral slots between the SD tuner and the installation frame, until the SD
tuner unlocks.
• Remove the fastening screw at the back of the unit.
• Carefully pull out the radio with the unlocking keys from the installation frame.
• Disconnect the ISO plug, the aerial plug and the LINE connections.
39