Cleaning The Solubles Circuit - Faema BARCODE Gebrauch Und Installation

WASHING THE SOLUBLES CIRCUIT
Only for machines with soluble products
Functioning: At the end of each soluble product dispensing
phase, the preset counter starts (from 1 to 20 minutes, OFF,
function disabled). Afterwards, the request to wash the circuit
will appear.
Activation: The washing cycle is performed after
simultaneously pressing and holding the keys (26)
(28) for at least a second.
Selection block: If the washing cycle is not performed within
60' after the message appears, with the "block soluble circuit"
function set (YES), the machine is blocked to prevent all
soluble-based selections.
Washing process: With water, completely automatically.
For more details, please see the technical manual at the
paragraph "Menu configuration – wash options".
Please follow these instructions for the washing process:
1) After the machine sends the message;
2) Open the door to access the programming keypad;
3) Keep keys (26)
appears with "WASHING IN PROGRESS" message:
wednesday
WASHING IN PROGRESS
Wait until the machine performs an automatic washing
cycle (approximately 2 minutes).
The washing cycle has ended when this message appears
on the display:
4) Press any dispensing key to return to normal work
operations.
The indications above are performed in addition to the solubles
circuit washing process described on the following page.
Downloaded from www.Manualslib.com
(Level 1)
CLEANING THE SOLUBLES CIRCUIT (WHERE PRESENT)
Level 1
and (28) pressed until the message
10 March 2010
15:15:04
WASH COMPLETED
MACHINE READY
PRESS ANY KEY
manuals search engine
1
and
2
3
4
63
26 28