Leica DMI3000B Bedienungsanleitung Seite 70

Variable Function Buttons on the Stand
The variable function buttons are assigned
functions at the factory that are appropriate to
the features of your microscope. They are
labeled accordingly. For details on button
assignments, please refer to the included
identification sheet.
For information on the abbreviations used,
please refer to the list ∅ p. 63.
Note:
The Leica Application Suite (LAS) software is
required for changing the button assignments.
Possible functions*:
BF CHANGE CUBE CW
PH CHANGE CUBE CCW
ICT INT FLUO
INT FLUO ¬
DF
IMC FD FLUO
FD FLUO ¬
POL
CHANGE TL CHG FW
INT IFW
INT ¬
ExMan
AP COMBI
AP ¬
CHANGE COMBI
FD CHANGE OBJ CW (only DMI6000 B)
FD ¬
CHANGE OBJ CCW (only DMI6000 B)
SHUTTER TL Z FINE (only DMI6000 B)
TL FLT 1 Z COARSE (only DMI6000 B)
XY PRECISE
TL FLT 2
FLUO XY FAST
CUBE 1 BTP ON/OFF (only DMI6000 B)
CUBE 2 DRY/IMM
CUBE 3 CHANGE FLT
CUBE 4 CHANGE CS
CUBE 5 OBJ 1-6
CUBE 6 MEM 1-6
* See page 63 for abbreviations
Fig. 85 Function buttons (left side of stand)
1 Variable function buttons
2 Open/close aperture diaphragm
3 TL/IL switching
4 Open/close field diaphragm
5 Increase/decrease light intensity
Fig. 86 Function buttons (right side of stand)
1 Variable function buttons
7. Start-up
1 2 3 4 5
1
67