Leica DMI3000B Bedienungsanleitung Seite 57

6. Assembly
Leica DMI3000 B:
To equip the turret disk with filter cubes, the tur-
ret disk must be removed from the stand (left side
of stand, Fig. 68).
The supports of the disk are labeled Pos1 to
Pos5 (Fig. 69).
• Pull the filter slider out of the stand.
• Insert the filter cubes in the supports so that
the labeling is upside down.
To do this, position the filter cube at the left
side and engage it to the right in the mount.
One position of the turret disk must remain
free for transmitted light bright field.
• When all filter cubes are inserted, push the
filter slider to the stop again in the left stand
side.
Fig. 68 Removing the filter slider
54
Fig. 69 Filter slider