Leica DMI3000B Bedienungsanleitung Seite 31

5. Unpacking the Microscope
Please carefully compare the contents of the de-
livery to the packing slip, delivery note or in-
voice. We strongly recommend storing a copy of
these documents with the manual to ensure that
you have information on the date and scope of
delivery handy for subsequent orders or service
work. Please ensure that no small parts remain
in the packing material. Parts of the packing ma-
terial are marked by symbols to simplify recy-
cling.
First, carefully remove all components from the
transportation and packaging materials.
Caution!
Do not put the instrument into operation in
the event of visible damage to the compo-
nents or packing material.
Note:
If at all possible, avoid touching the lens sur-
faces of the objectives. If fingerprints do appear
on the glass surfaces, remove them with a soft
leather or linen cloth. Even small traces of finger
perspiration can damage the surfaces in a short
time. See the chapter "Care of the Microscope"
∅€p. 109, for additional instructions.
28
Caution!
Do not connect the microscope or periph-
erals to an AC power source at this time
under any circumstances!
Installation Location
Work with the microscope should be performed in
a dust-free room, which is free of oil vapor and
other chemical vapor, as well as extreme humidity.
At the workplace, large temperature fluctuations,
direct sunlight, and vibration should be avoided.
These may adversely affect measurements and
long-term observations.
Allowable ambient conditions
Temperature
Relative humidity
Microscopes in warm and warm-damp climatic
zones require special care in order to prevent
the build up of fungus.
See the chapter "Care of the Microscope"
∅ € € € € € p. 109, for additional instructions.
Caution!
Electrical components must be placed at
least 10 cm from the wall and away from
flammable substances.
15–35°C
maximum 80% up to 30°C