Installation Of Filters In The Illumination Arm; Installing The Transmitted Light Lamp Housing - Leica DMI3000B Bedienungsanleitung

6. Assembly

6.8 Installation of Filters in the Illumination Arm

The Leica DMI Series is equipped with a filter
magazine to accommodate two 40 mm dia.
filters as a standard feature. The filters are
factory-installed. To change filters yourself,
proceed as follows:
• Release the screw (46.1) and remove the cover.
• Place the filter in the holder.
• Place the cover on transmitted light illumination
carrier and fasten with the locking screw.
Leica DMI6000 B:
• Activate the filters via the Leica Application Suite
(LAS).
Leica DMI3000 B and Leica DMI4000 B:
• Mark the 2 levers with the provided adhesive la-
bels.
Fig. 46 Unscrewing the filter holder cover and inserting
filters in the transmitted light illumination arm
1 Screw
1
Fig. 48 Lamp housing cabling (cable duct)
44
6.9 Installing the transmitted Light Lamp
Housing
• Place the lamp housing in the transmitted
light lamp housing mount (Fig. 47), and fasten
it with the clamping screw on the side.
• Thread the cable through the transmitted light
illumination arm (Fig. 48).
• Connect the lamp housing cable to the power
supply for transmitted light on the Leica
CTR4000–7000 electronics box (Fig. 49.1).
Leica DMI3000 B:
• For the DMI3000 B, connect the cable directly
to the back of the microscope.
For instructions on changing the lamp, please
see Chapter 6.10.
These instructions also apply to installing an Hg
lamp on the transmitted light axis.
descriptions of the
replacement of the burner, please see Chapter
6.12, ∅ p. 48ff.
Fig. 47 Mounting the lamp housing on the
transmitted light illumination arm
Fig. 49 Connecting the lamp housing to the
Leica electronics box, example: Leica CTR6000
For
lamp housings and
1