Option Screen - JVC RM-P2580 Bedienungsanleitung

OPTION SCREEN

Item
MAX CAMERA Sets the maximum number of connected cameras.
(Displayed at B Sets the number of cameras to be displayed in the CAMERA
Mode only) SELECTION screen.
P/T SPEED Sets the number of speed steps to be varied according to the
tilting angle during manual operation of the PAN/TILT control
lever.
SERIAL-2 Function not available Make sure that it is set to "OFF".
(Displayed at B
Mode only)
CAMERA Sets to disable or enable the camera selection of each camera.
SELECTION AUTO
(Displayed at A
Mode Only)
ENABLE : Camera selection is possible even if the correspond-
DISABLE : Camera selection is disabled.
NOTE:
Make sure to set to ENABLE when switching the video
signal of the unit with the CAM SW signal from a time lapse
VTR. Even if it is set to AUTO, the video signal will not be
switched.
FACTORY Resets all values to the factory-set defaults.
SETTING CANCEL : Reset to the factory-set defaults does not occur
EXECUTE : When the SET button is pressed, the "NOW EX-
NOTE:
The POSITION setting is not returned to the default value.
Function
: The sync signal of each camera connected is
checked in turn and the camera can be selected if it
is connected correctly.
ing camera is not connected. A blue screen is dis-
played when a camera input is selected without a
camera being connected.
but return to the OPTION screen occurs.
ECUTING" is displayed and the values are reset
to the factory-set defaults. At this time "TURN
POWER OFF" is displayed, be sure to then turn
the power off and then to ON again in order to
restart.
5. MENU SCREEN SETUPS
Options Default
1, 2,... 15, 16 16
Slow
2 STEPS, 8 STEPS
4 STEPS,
6 STEPS,
Fast
8 STEPS
OFF, OFF
A,
B
AUTO, AUTO
ENABLE,
DISABLE
CAMERA SELECTION
CAMERA 1 AUTO
CAMERA 2 AUTO
CAMERA 3 AUTO
CAMERA 4 AUTO
CAMERA 5 AUTO
CAMERA 6 AUTO
CAMERA 7 AUTO
CAMERA 8 AUTO
CANCEL, CANCEL
EXECUTE
FACTORY SETTING
CANCEL
EXECUTE
E-29