Auto Sequence Operation - JVC RM-P2580 Bedienungsanleitung

AUTO SEQUENCE OPERATION

Operation with the Basic System
When the AUTO button is pressed, the AUTO indicator lights up and the MONITOR OUTPUT connectors output the camera
images, switching them in order of camera numbers at constant intervals.
(Example) When using cameras 1 to 6
Camera 1
Camera 6
CAMERA CAMERA
SETUP SETUP
POWER
ALARM
MENU MENU SET SET
KEY LOCK
CAMERA display
POSITION display
( REF. : Page 32 for the switching interval setting.)
Camera 2
Camera 5
Lights up.
AUTO button
RM-P2580
REMOTE CONTROL UNIT REMOTE CONTROL UNIT
POSITION POSITION
AUTO AUTO F-1 F-1 F-2 F-2 F-3 F-3
2. BASIC OPERATIONS
Camera 3
Camera 4
1.
Press the AUTO button.
The LED indicator lights up and the AUTO SEQUENCE
operation starts.
The CAMERA display shows the camera number of the
video being output from the MONITOR OUTPUT 1 con-
nector.
The POSITION display shows the camera operation de-
tails. ( REF. : Page 10)
NOTES
● During the AUTO SEQUENCE operation, the camera
selection, manual selection, AUTO PAN operation and
AUTO PATROL operation are not available.
● When the auto mode AUTO SEQUENCE operation is
switched from ON to OFF, the MONITOR OUTPUT con-
nectors output the video at the moment of the ON-OFF
switching.
● In the case of Applied System (B Mode), the video from
the MONITOR OUTPUT is displayed in either auto se-
quence or in multi-split screen depending on the setting
of the connected frame switcher.
2.
To stop the AUTO SEQUENCE operation, press the AUTO
button once again.
E-13