5. MENU SCREEN SETUPS
MENU OPERATION
SET button
MENU button
CAMERA
CAMERA
SETUP
SETUP
POWER
PO
WER
ALARM
ALARM
MENU
MENU
SET
SET
KEY LOCK
KEY LOCK
LENS
LENS
CAMERA/POSITION
1
2
SPEED
SPEED
4
5
IRIS
IRIS
CLOSE
CLOSE
OPEN
OPEN
FOCUS
FOCUS
7
8
NEAR
NEAR
FAR
FAR
AF
0
WIDE
WIDE
ZOOM
ZOOM
TELE
TELE
CLEAR
CLEAR
/HOME
/HOME
Cursor
Item
SETUP
POSITION SETUP..
CAMERA..
CONTROL UNIT..
SETUP screen (Main menu)
OPTION
P/T SPEED
CAMERA SELECTION..
FACTORY SETTING..
Example of sub-menu screen
(Displayed at A Mode Only)
Change marking
OPTION
P/T SPEED
CAMERA SELECTION..
FACTORY SETTING..
Example of sub-menu screen after change
(Displayed at A Mode Only)
E-26
PAN/TILT
control lever
RM-P2580
RM-P2580
REMOTE CONTROL UNIT
REMOTE CONTROL UNIT
POSITION
POSITION
AUTO
AUTO
F-1
F-1
F-2
F-2
F-3
F-3
PAN/TILT
PAN/TILT
3
CAMERA
POSI-
POSI-
TION
TION
6
OPTION
OPTION
OPTION
OPTION
1
2
9
AUTO
AUTO
PAN
PATROL
ENTER
ENTER
Sub-menu available
8STEP
8STEP
1.
Set the POWER switch on the rear panel to "ON".
2.
Press and hold the MENU button for about 3 seconds.
The LED indicator lights up and the MONITOR OUTPUT
1 connector on the rear panel outputs the SETUP screen
signal.
3.
Select a menu item by moving the cursor (>) using the
PAN/TILT control lever.
• Tilt the lever upwards (8) to move the cursor upwards.
• Tilt the lever downwards (9) to move the cursor down-
wards.
4.
Press the SET button to display the sub-menu of the menu
item selected.
NOTE
The items which have ".." at the end have the sub-menus
under them.
5.
3
As in step
, select the desired item in the sub-menu.
6.
Change the value of the selected item using the PAN/TILT
control lever.
• Tilt the lever towards the left (;) to decrease the value.
• Tilt the lever toward the right (:) to increase the value.
When the value of an item is changed, the marking (✽)
appears as shown on the left.
NOTE
For details off the sub-menu setting procedure, see subse-
quent pages.
7.
After changing the items as required, press te MENU but-
ton to return to the normal video display screen.
NOTES : While the menu screen is being displayed :
● The functions of AUTO SEQUENCE, AUTO PAN and
AUTO PAN cease to operate.
● The alarm functions are disabled.
● The CAMERA SW is disabled.
● Remaining in operation are camera select, preset (home)
position select, data output and manual control.