F) Switch Time Display; Alarm Function - Conrad Profi Bedienungsanleitung

f) Switching the Time Display
Briefly push the button „MODE" (B3) repeatedly to switch between the following displays:
• Current time (hour/minute/second)
• Alarm time 1 (hour/minute), icon „
• Alarm time 2 (hour/minute), icon „
• Year
If no button is pushed anymore, the display switches back to the current time automatically after
a few seconds.
g) Alarm Function
Displaying the Alarm Time
Push the button „MODE" (B3) briefly several times until alarm time 1 or 2 is displayed and the
symbol „ " or „ " flashes in the upper right of the display; see chapter 10. f).
Switching the Alarm Function On/Off
• When the alarm time 1 or 2 is displayed and the associated symbol flashes, briefly push the
button „AL ON/OFF" (B2) to switch the alarm function on or off.
• With the alarm function on, „on" appears to the right of the alarm time; if the alarm function is
off, „off" appears.
Setting Alarm Time
• When the alarm time is displayed (1 or 2), keep the MODE" (B3) pushed for about 3 seconds until
a sound signal is issued and the hours of the alarm time flash. Release the button again.
• Set the hours of the alarm time with the button „8 (12/24)" (B11) or „2/
Keeping the respective button down for some time will adjust them quickly.
If you do not push any button for about 15 seconds, the weather station saves all input and
leaves the setting mode automatically.
• Briefly push the button „MODE" (B3); the displayed minutes of the alarm time flash.
• Set the hours of the alarm time with the button „8 (12/24)" (B11) or „2/
• Push the button „MODE" (B3) briefly again to save all settings and leave the setting mode
(alternatively, wait for a few seconds without pushing a button).
58
" flashes in the upper right of the display
" flashes at the upper right of the display
" (B12).
" (B12).