Cleaning - Storch Airless EasySpray ES 300 Bedienungsanleitung

Cleaning

Cleaning the sprayer after each use results in a trouble
free start up the next time the sprayer is used.
• See the section on warehousing for information on
long-term storage.
• See the section on suitable cleaning fluids and anti-sta-
tic grounding instructions for oil-based substances.
Cleaning Fluid Compatibility
Oil- or Water-based Materials
• When spraying water-based materials, flush the system
thoroughly with water.
• Thoroughly flush the system with spirit or compatible
solvents when spraying solvent/oil-based materials.
• After having cleaned the system with compatible
solvent, initially flush the system with hot, soapy
water and then flush it with plenty of water to spray
water-based substances after having used the spray
gun to apply solvent/oil-based substances. The water
flowing out of drain tube should be clear and sol-
vent-free before you begin spraying the water-based
material.
• After having cleaned the system with water, thoroughly
flush the system with spirit or a compatible solvent to
be able to apply oil-based materials after having used
the spray gun to apply water-based materials. The
solvent flowing out of the drain tube should not con-
tain any water. Always observe anti-static grounding
instructions when flushing with solvents(solvent/oil-ba-
sed substances).
• To avoid fluid splashing back on your skin or into your
eyes, always aim gun at inside wall of pail.
1. Carry out pressure relief procedures.
2. Remove the tip guard and spray tip.
3. Remove the intake/drain pipes from the paint and wipe
off excess paint.
Original instruction
4. Separate the drain tube (small) from the intake pipe
(large).
5. Place empty waste and flushing fluid pails side by side.
6. Submerge the intake pipe in the flushing agent. Use
spirit or compatible solvents for solvent/oil-based paint
and water for water-based paint. Place drain tube in
waste pail.
7. Turn the pressure regulator to Prime/Clean.
8. Set the Prime/Spray valve to PRIME (horizontal).
9. Set the on/off switch to ON.
10. Flush until approximately 1/3 of the flushing fluid is
emptied from the pail.
158