Bypass Valve - Storch Airless EasySpray ES 300 Bedienungsanleitung

Bypass valve

In PRIME position (vertical) the paint is fed in from the
paint container via the intake pipe.
PRIME
In SPRAY position (horizontal) this valve guides the pres-
surised material to the spray gun through the paint hose.
SPRAY
Flush Storage Fluid
This sprayer arrives from the factory with a small amount
of test material in the system. It is important that you
flush this material from the sprayer before using it for the
first time. See "Cleaning Fluid Compatibility" and "Static
Grounding Instructions (Oil-Based Materials)" for additio-
nal information when using oil-based materials.
1. Carry out pressure relief procedures.
2. Make sure the on/off switch is OFF.
3. Separate drain tube (small) from the intake pipe (lar-
ge).
4. Place drain tube in a waste pail.
5. Submerge suction tube in a pail partially filled with
water or flushing fluid.
6. Set the bypass valve horizontally to PRIME position.
7. Plug power supply cord into a correctly grounded
electrical outlet.
8. Operate the valve button twice to disengage the inlet
ball.
9. Align setting indicator with Prime/Clean setting on the
pressure regulator.
10. Turn ON/OFF switch to ON position.
11. When sprayer starts pumping, flushing solvent and air
bubbles will be purged from system. Allow fluid to flow
out of drain tube, into waste pail, for 30 to 60 seconds.
12. Turn ON/OFF switch to the OFF position.
High-pressure spray is able to inject toxins into the body
and cause serious bodily injury. Do not stop leaks with
hand or rag.
13. Inspect for leaks. If leaks occur, perform Pressure
Relief Procedure, page 11, then tighten all fittings and
repeat Start Up. If there are no leaks continue with the
next step.
153 Original instruction