Quickclean Cleaning Adapter - Storch Airless ST 450 Bedienungsanleitung

2. Use a smaller tip size and/or dilute the coating materi-
al if pressure adjustment cannot eliminate stripes (please
observe the manufacturer's instructions here).
3. Hold gun perpendicular, 25 - 30 cm from the surface.
Spray back and forth within width; overlap by 50 %.
4. Trigger gun after moving. Release trigger before stop-
ping.
Clear Tip Clog
In the event that particles or debris clog the spray tip, this
sprayer is designed with a reversible spray tip that quickly
and easily clears the particles without disassembling the
sprayer.
1. Engage trigger lock. Rotate spray tip 180° to unclog
position. Disengage trigger lock. Point the spray gun at
the waste pail and briefly pull the trigger to unclog it.
Nozzle table/nozzle selection guide
Glazes
Processable ma-
Alkyd resin lacquer
terials
Acrylic lacquer
Spray width 7 9 10
10 cm 207 209 210
15cm 307 309 310
20cm 409 410
25cm
30cm
35cm
QuickClean cleaning adapter for efficient cleaning
The QuickClean adapter requires a water connection, a
water hose with connection coupling (e.g. Gardena) and a
bucket to collect the dirty water.
Proceed as follows:
Original instruction
Interior emulsions
Primers
Exterior emulsions
Pre-coats
Adhesive for fibreglass wallpaper
Nozzle drilling in 1/1000" (example: 8 = 0.008") and nozzle marking
11 12 13 15 17 19
211 212 213 217 219
311 313 315 317 319
411 413 415 417 419
511 513 515 517 519
619
1. Ensure the Airless
gun trigger has been
locked and the rever-
sing tip has been
removed from the tip
holder.
NOTE: If spray tip is difficult to rotate when turning to
the unclog position, perform Pressure Relief Procedure,
then turn circulation valve to spray position and repeat
step 1.
2. Engage the trigger lock. Rotate spray tip back to spray
position. Disengage trigger lock and continue spraying.
Flame protection
Bitumen material
Light filler
21 23 25 27 29
321
421 423 425
521 523 525 527 529
621 623 625 627
721
140
Other spray fillers
31 33 35 37 39 41
235
431
531 535
631 633 635 637 639 641
735
2. Remove the vacu-
um hose from the
container and clean it
(including vacuum fil-
ter) on the outside with
water or a compatible
solvent. Unscrew the
vacuum filter from the
vacuum pipe and clean
the container.
43
543
643