List Of Spare Parts Of Paint Level; Maintenance Of Outlet Valve Assembly - Storch Duomax 9000 Bedienungsanleitung

Item Designation
1 Pump cylinder
2 O-ring housing extension
3 Medium paint level housing
4 Upper paint level housing
5 Upper piston rod
6 Piston end
7 Medium piston rod
8 Outlet valve cage
9 Ball for outlet valve
10 Outlet valve seat
11 Outlet valve holder
12 Inlet valve holder
13 Inlet valve seat
14 Suction sieve
15 O-ring Teflon for seal holder
Paint level SL 1100
Maintenance of paint level for Duomax 9000

MAINTENANCE OF OUTLET VALVE ASSEMBLY

Disassembly of outlet valve - Figure 2
1. Remove material pump from machine.
2. Removing the outlet valve assembly
3. Carefully hold piston end 6 in vice bottom up and
loosen valve holder 6 using a 7/16" hexagonal
spanner.
4. Remove outlet seat 10. Do not force open, which
would otherwise splinter the edges.
5. Remove Teflon O-ring, outlet ball 9 and outlet ball
guide 8.
6. Remove all old packings and glands from outlet
housing; save support rings 19 and 22; they will be
re-used unless damaged.
7. Clean and inspect parts for wear or damage, replace
parts as necessary. Teflon O-ring 27 must always
be replaced in this procedure.
Re-assembly of outlet valve - Figure 13
1. Install ball guide 8, ball 9, seat 10 and O-ring 27
into piston end.
2. Install valve holder 11 in piston end 6; torque 41
Nm.
3. Install new packings, glands and scraper.
Art. No.
Item Designation
69 61 72
16 O-ring inlet valve cage
69 60 32
17 Inlet valve housing
69 60 33
18 Inlet valve ball
69 60 34
19 Support ring top underside
69 60 35
20 Seal, plastic
69 60 36
21 Seal, leather
69 60 37
22 Support ring, upper side
69 60 38
23 Wiper for piston
69 60 39
24 Sealing nut
69 60 40
25 Lock nut, piston end piece
69 60 41
26 Lock nut
69 60 42
27 O-ring, Teflon
69 60 43
29 Retaining bolt for piston
69 60 44
30 O-ring, suction sieve
69 01 21
116
Art. No.
69 60 46
69 60 47
69 60 48
69 61 69
69 61 71
69 61 70
69 61 68
69 60 49
69 61 67
69 60 08
69 61 77
69 60 50
69 60 52
69 60 53