Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INITIAL SET-UP
Tuning terrestrial channels
(DVB-T)
1 In the »Source Setup« menu, in the
»Connection Type« line, select the option
<
»Air« with »
« or »
2 Select the line »Scan Type« with »
»
«.
Λ
<
>
Use »
« or »
type:
– »DTV«, scan for digital television channels;
– »ATV«, scan for analogue television
channels;
– »ATV & DTV«, scan for analogue and
digital television channels.
Caution:
The antenna power supply (5V
7
only be switched on if the antenna is an
active indoor antenna with a signal
amplifier and it is not already supplied with
a voltage via a mains plug (or similar
supply). Otherwise you may cause a short
circuit and irreparably damage your
antenna.
3 Select the line »Active Antenna Power« with
»
« or »
«.
V
Λ
Switch on the antenna power supply for the
antenna with »
4 Start the scan with » « (green).
– The »Search Results« menu appears, and
the search for channels begins.
– Depending on the number of channels
received, this can easily take a few
minutes.
– The scan is complete as soon as the
»PROGRAM TABLE« appears.
Note:
You can abort the scan by pressing
7
»MENU«.
5 Press »MENU« to end the setting.
Note:
Before recording HD channels, please
7
check signal quality and Strength, see
chapter "Displaying signal information" on
page 72. If the level is displayed in green,
you can record HD channels without any
problems.
EN 80 / 20
---------------------------------------------------------------------------------------------------
>
«.
« or
V
« to set the required scan
) may
<
>
« or »
« (»On«).
Tuning channels from the cable
provider (DVB-C)
1 In the »Source Setup« menu, in the
»Connection Type« line, select the option
<
»Cable« with »
« or »
2 Select the line »Scan Type« with »
»
«.
Λ
<
>
Use »
« or »
« to set the required scan
type:
– »DTV«, scan for digital channels;
– »ATV«, scan for analogue television
channels;
– »ATV & DTV«, scan for analogue and
digital television channels.
3 Select the line »Cabel Scan Type« with
»
« or »
«. Select the preferred option
V
Λ
(»Quick« or »Full«) with »
– The search function »Quick« sets up the
channels according to the information
provided by your cable provider in the
transmission signal.
– If the option »Full« is selected, the entire
frequency range will be scanned. The
search can take a long time with this
option. This option is recommended if
your cable provider does not support the
scan type »Quick«.
Note:
You can accelerate the search. To do this,
7
you need information about the frequency
and network ID. You are usually able to get
this data from your cable operator or find it
in forums on the Internet.
4 Start the scan with » « (green).
– The »Search Results« menu appears, and
the search for channels begins.
– Depending on the number of channels
received, this can easily take a few
minutes.
– The scan is complete as soon as the
»PROGRAM TABLE« appears.
Note:
You can abort the scan by pressing
7
»MENU«.
5 Press »MENU« to end the setting.
Television / User Manual
>
«.
« or
V
<
>
« or »
«.
Werbung
Inhaltsverzeichnis
