Displaying Signal Information - Beko B40L 5741 4B Handbuch

SETTING FURTHER CHANNELS
Skipping television channels
You can highlight television channels to be
skipped when you select with »
Selection is still possible using the number
buttons.
1 In the »PROGRAME TABLE« menu, switch
over to the list view with »
2 Select the preferred channel with »
or » «.
Λ
3 Select the column »Skip« with »
and use »OK« to mark the channel.
– The channel is marked using »✔«.
Note:
Channels can also be reactivated. Select
7
the channel with »
the column »Skip« and reactivate the
channel with »OK«.
Creating lists of favourites
You can select your favourite channels and
save them in up to four favourites lists (Fav 1 to
Fav 4).
1 In the »PROGRAME TABLE« menu, switch
over to the list view with »
2 Select the preferred channel with »
or » «.
Λ
< >
3 Use » « or »
one of the favourites lists 1 to 4 and press
»OK« to confirm.
– The position in the favourites list is marked
with »✔«.
– You can enter the same channel in more
than one favourite list.
– Each favourite list can store up to
250 channels.
Note:
Channels can also be deleted from
7
favourites lists. Select the channel to be
deleted with »
delete it with »OK«.
Exiting the settings
1 Press »MENU« to end the setting.
EN 80 / 72
« or »
Λ V
« (yellow).
V
<
« or »
« or » «, then select
V Λ
« (yellow).
V
« to "push" the channel into
< >
«, » «, » « or » « and
V Λ
-----------------------------------------------------

Displaying signal information

(for digital channels only)
«.
1 Open the menu with »MENU«.
2 Select the menu item »SOURCE SETUP«
with »
V
confirm.
3 Select the line »Signal Information« with
«
» « or »
V
– Information on the channel, network,
>
«
modulation, symbol rate, quality and
signal strength is displayed.
Notes:
The signal information changes in ac cord-
7
ance with the current input source.
The signal properties are displayed in the
7
lower section of the menu. The further the
bars for »Quality« and »Signal Strenght«
extend to the right, the better the reception
signal.
The signal level not only depends on your
7
receiver system, but also on the channel
which is currently active. Remember this
when aligning your antenna based upon
the signal level display.
«
4 Press »MENU« to close the menu.
« or » « and press »OK« to
Λ
« and press »OK« to confirm.
Λ
Television / User Manual