Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SETTING FURTHER CHANNELS
Update for digital channels from
a satellite automatically
Satellite data changes frequently, new channels
are constantly being added. You should
therefore perform an automatic search from time
to time.
This searches all transponders for new channels.
1 Open the menu with »MENU«.
2 Select the menu item »SOURCE SETUP«
with »
« or »
« and press »OK« to
V
Λ
confirm.
– The »SOURCE SETUP« menu appears.
SOURCE SETUP
Source
Automatic Channel Search
Digital Manual Tuning
Antenna Settings
Program Table
Signal Information
Automatic Service Update
CA -Module
Exit
Back
3 Select the line »Source« with »
and press »OK« to confirm.
Select the input source »Satellite« with »
>
»
«, »
« or »
« and press »OK« to
V
Λ
confirm.
4 Select the line »Automatic Channel Search«
with »
« or »
« and press »OK« to
V
Λ
confirm.
– The menu appears.
5 Select the line »Select Satellites« with »
or »
« and press »OK« to confirm.
Λ
– The »SELECT SATELLITE« menu appears.
6 Select a satellite with »
»
« and press »OK« to confirm.
Λ
Television / User Manual
xx.xx.xxxx
15:46
Satellite
OK
Off
Not Inserted
« or »
«
V
Λ
<
«,
«
V
<
>
«, »
«, »
« or
V
-----------------------------------------------------
7 Select the line »Scan Mode« with »
»
«.
Λ
Select the scan mode with »
(for unencrypted channels, for encrypted
channels only, or both).
8 Select the line »Service Type« with »
»
«.
Λ
<
>
Use »
« or »
« to select whether you want
to search for television channels (TV) only,
radio stations only (Radio) or both
(Radio + TV).
9 Select the line »Network Search« with »
or »
«.
Λ
Select the option »On« with »
– If the »Network Search« is set to »On«,
the data will be accessed via the new
transponder of the network which has
been set.
10 Start the scan with » « (red).
Note:
If the previously stored channels should
7
be retained in the channel list and the new
channels found be added to it, then press
» « (green).
If » « (red) is pressed, the saved channels
will be deleted from the current channel list.
– The »Results« menu appears, and the scan
for channels begins.
– Depending on the number of channels
received, this can easily take a few
minutes.
– The search is complete as soon as the
»PROGRAM TABLE« appears.
Note:
You can abort the search by pressing
7
»MENU«.
11 Press »MENU« to end the setting.
« or
V
<
>
« or »
«
« or
V
«
V
<
>
« or »
«
EN 80 / 61
Werbung
Inhaltsverzeichnis
