SETTING FURTHER CHANNELS
Antenna settings, SCR system
and searching for digital
channels from a satellite
automatically
Notes:
Your TV supports SCR system (Single Chan-
7
nel Router – EN 50494).
The following description about the LNB
7
settings premise a substantial expertise
about the satellite systems. Ask your
specialist dealer.
1 Open the menu with »MENU«.
2 Select the menu item »SOURCE SETUP«
with »
« or »
V
confirm.
3 Select the line »Source« with »
and press »OK« to confirm.
Select the input source »Satellite« with »
>
»
«, »
« or »
V
confirm.
4 Select the line »Antenna Settings« with »
or »
« and press »OK« to confirm.
Λ
– The menu appears.
5 Select and set the required option for the
antenna settings with »
Satellite
Press »OK« then select the required satel-lite
<
>
with »
«, »
«, »
»OK« to confirm.
LNB Type
If your antenna system is equipped with
a single-cable system multiswitch, use the
op-tion »SCR«. Press »OK« and select the
»SCR« option with »
»LNB-Frequency High« line with »
enter the frequency with »1...0« in five
digits.
Select the »LNB-Frequency Low« line with
»
« and enter the frequency with »1...0«
V
in five digits.
Confirm the settings with » « (green).
User Band
Select the number of the antenna socket
<
used with »
« or »
EN 80 / 64
« and press »OK« to
Λ
« or »
V
« and press »OK« to
Λ
« or »
«:
V
Λ
« or »
« and press
V
Λ
<
>
« or »
«. Select the
« and
V
>
«.
-----------------------------------------------------
UB Frequency (MHz)
Enter the required frequency for the selected
antenna socket with »1...0«.
LNB Selection
Depending on the number of LNBs, select
the option with »
1/2« if only 1 LNB is used; if two LNBs are
used, select the required LNB (»1/2« or
»2/2«).
Notes:
Use installation equipment supported / sug-
7
gested by your SCR Switch.
Other users / receivers connected to the
7
system may be affected if the specified user
band number and frequency is changed
during installation.
«
Λ
User band and user band frequency is
7
specified on the SCR switch used; and each
<
«,
user / receiver must select a specified user
band and user band frequency.
With SCR satellite system, auto search by
7
several users / receivers at the same time
«
V
may cause problems.
6 Select »Auto Tuning« by presing » « (red).
7 Select the line »Scan Mode« with »
»
«.
Λ
Select the scan mode with »
(for unencrypted channels, for encrypted
channels only, or both).
8 Select the line »Service Type« with »
»
«.
Λ
<
Use »
« or »
to search for television channels (TV) only,
radio stations only (Radio) or both
(Radio + TV).
9 Start the scan with » « (red).
– The »Results« menu appears, and the scan
for TV channels begins.
<
>
« or »
«.
V
<
>
« or »
>
« to select whether you want
Television / User Manual
« or
«
« or
V