Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INITIAL SET-UP
6 Select the line »DISEqC Mode« with »
or »
«.
Λ
Select »DiSEqC 1.0« or »DiSEqC 1.1«
in accordance with the existing antenna
<
system with »
« or »
– DiSEqC 1.0 allows up to four satellites to
be received simultaneously.
– DiSEqC 1.1 allows up to 16 satellites to
be received simultaneously.
7 Select the line »LNB Selection« with »
or »
«.
Λ
Select the setting for the respective satellites
<
>
with »
« or »
«.
8 Once the settings for the satellite have
been made, switch to the »AUTOMATIC
CHANNEL SEARCH« menu with » « (red).
SOURCE SETUP
AUTOMATIC CHANNEL SEARCH
Connection Type
Country
Operator Selection
Select Satellite
Scan Mode
Service Type
Network Search
MENU
Back
9 Select the line »Scan Mode« with »
»
«.
Λ
Select the scan mode with »
(for unencrypted channels, for encrypted
channels only, or for both).
10 Select the line »Service Type« with »
»
«.
Λ
<
>
Use »
« or »
« to select whether you
want to search for television channels only
(TV), radio stations only (Radio) or both
(Radio + TV).
Television / User Manual
---------------------------------------------------------------------------------------------------
«
V
>
«.
«
V
xx.xx.xxxx
15:46
Satellite
Other
Standard Mode
ASTRA 19.2°,E
Free + Scramble
All
All
Off
Start Search
« or
V
<
>
« or »
«
« or
V
Note:
It is possible, that some TV channels
7
(transponders) cannot be found. This is
caused by a change in satellite parameters
made by the broadcaster, e.g. new
channels have been added. Set the
»Network Search« option to »On«.
11 Start the scan with » « (red).
– The »Results« menu appears, and the scan
for channels begins.
– Depending on the number of channels
received, this can easily take a few
minutes.
– The scan is complete as soon as the
»PROGRAM TABLE« appears.
Note:
You can abort the scan by pressing
7
»MENU«.
12 Press »MENU« to end the setting.
Note:
If other television channels are to be tuned
7
from a second satellite, proceed as follows:
Open the menu with »MENU«, select the
line »SOURCE SETUP« with »
and press »OK« to confirm. Then select the
»Automatic Channel Search« with »
»
« and press »OK« to confirm. Confirm
Λ
the line »Select Satellite« with »OK« and
select the preferred satellite with »
<
>
»
« or »
«. Start the scan with » « (red).
Continue the adjustment by step 4 of the
chapter.
Note:
Before recording HD channels, please
7
check signal quality and Strength, see
chapter "Displaying signal information" on
page 72. If the level is displayed in green,
you can record HD channels without any
problems.
« or »
«
V
Λ
« or
V
«, »
«,
V
Λ
EN 80 / 19
Werbung
Inhaltsverzeichnis
