Beko B40L 5741 4B Handbuch Seite 140

SETTING FURTHER CHANNELS
Searching for digital channels
from a satellite manually on a
transponder
If a certain channel cannot be found with
automatic search, you can search it manually
by manual search function. You must enter all
parameters of the channel correctly. You can
obtain the current transponder information from
teletext page, satellite TV magazines or internet.
1 Open the menu with »MENU«.
2 Select the menu item »SOURCE SETUP«
with » « or »
V
confirm.
– The »SOURCE SETUP« menu appears.
3 Select the line »Source« with »
and press »OK« to confirm.
Select the input source »Satellite« with »
>
» «, » « or »
V
confirm.
4 Select the line »Digital Manual Tuning « with
» « or » « and press »OK« to confirm.
V Λ
– The menu appears.
5 Select the required option for manually
adjusting with »
Transponder
Enter the transponder frequency with
»1...0« in five digits.
Symbol Rate (Ksym/s)
Enter the transponder symbol rate with
»1...0« in five digits.
Polarization
Set the polarisation for the transponder to
Horizontal« or »Vertical« using »
Network Search
Select the network search with »
as »On« or »Off«.
Scan Mode
< >
Use » « or »
to search for unencrypted (Unencrypted)
channels only, encrypted (Encrypted)
channels only, or for both (Unencrypted +
Encrypted).
EN 80 / 62
« and press »OK« to
Λ
« or »
V
« and press »OK« to
Λ
« or » «.
V Λ
<
« or »
<
« or »
« to select whether you want
-----------------------------------------------------
Service Type
<
Use » « or »
to search for television channels only (TV),
radio stations only (Radio), or both (Radio
+ TV).
6 Start the scan with » « (red).
– The »Results« menu appears, and the scan
for TV channels begins.
Note:
You can abort the search by pressing
7
»MENU«.
7 Press »MENU« to end the setting.
«
Λ
<
«,
>
«.
>
«
>
« to select whether you want
Television / User Manual