Beko B40L 5741 4B Handbuch Seite 144

SETTING FURTHER CHANNELS
DISEqC Mode
Based on the number of current satellite
system, select the option »Off«, »DiSEqC
1.0« or »DiSEqC 1.1« with »
– »Off«: For satellite systems with single
antenna.
– »DiSEqC 1.0« switch allows for receiving
from maximum four satellites at the same
time.
From »LNB Selection« use »
to make the »1/4«, »2/4«, »3/4«
or »4/4« selection for the satellite
that corresponds to relevant DiSEqC
positions.
– »DiSEqC 1.1« switch allows for receiving
from maximum sixteen satellites at the
same time.
From »LNB selection« use »
>
» « to make the selections between
»1/16« and »16/16« for the satellite
that corresponds to relevant DiSEqC
positions.
6 Select »Auto Tuning« by presing » « (red).
7 Select the line »Scan Mode« with »
» «.
Λ
Select the scan mode with »
(for unencrypted channels, for encrypted
channels only, or both).
8 Select the line »Service Type« with »
» «.
Λ
< >
Use » « or »
to search for television channels (TV) only,
radio stations only (Radio) or both
(Radio + TV).
9 Start the scan with » « (red).
– The »Results« menu appears, and the scan
for TV channels begins.
Notes:
When updating via the same satellites a
7
security query is displayed at the start of a
search.
If the previously stored channels should
7
be retained in the channel list and the new
channels found be added to it, then press
» « (green).
EN 80 / 66
< >
« or » «.
<
« or »
<
« or
V
< >
« or » «
V
« to select whether you want
-----------------------------------------------------
If » « (red) is pressed, the saved channels
7
will be deleted from the current channel list.
– The »Results« menu appears, and the scan
for channels begins.
– Depending on the number of channels
received, this can easily take a few
minutes.
– The search is complete as soon as the
»PROGRAM TABLE« appears.
>
Note:
«
You can abort the search by pressing
7
»MENU«.
10 Press »MENU« to end the setting.
Note:
Repeat the procedure from point 1 for the
7
settings of the second satellite or any others.
These channels will be added to the bottom
of the channel table.
« or
« or
Television / User Manual