Ozone Enzo2 Bedienungsanleitung Seite 14

Step 3 Group together the middle/
trailing edge of the wing by sorting
the folds near the B and C tabs.
If using a Saucisse pack go to Step 7
Step 4 Once the LE and TE of the
wing have been sorted, turn the
whole wing on its side.
Step 5 Strap the Folding Pillow below
the LE - at the point of the first fold.
The pillow reduces the angle of the
fold and helps preserve the plastics.
Next fold the TE around the
LE being careful to not
fold with tight angles
Step 6 Now place the wing into the stuff sack.
Step 7. If using the Saucisse Pack
carefully do it up without trapping any
material.
Step 8. Turn the Saucisse on its side,
lay the foam Folding Pillow in place and
make the fold of the LE around it. Use 3
folds.
IMPORTANT: Do NOT lay the wing flat on the ground before
packing the glider, this will cause abrasion damage to the top
surface as you pull the glider towards the middle. ALWAYS pack
from a mushroom or lift the wing off the ground when gathering
the wing and grouping the leading edge.
Important: Do not fold the glider in the centre, you will
bend the plastics, instead pack the wing with a full concer-
tina method from tip to tip before packing into the stuff sac.
12