Troubleshooting - Cleanmaxx Z 06439 Gebrauchsanleitung

EN
8. When all parts are fully dry, insert the plastic dust fi lter back into the dust container.
9. Place the fabric fi lter back onto the plastic dust fi lter.
10. Place the dust container lid back onto the dust container and turn it tight.
11. Insert the dust container back into the motor unit by fi rst hooking the bottom part of
the dust container onto the motor unit and then pressing it against the motor unit until
the release button for the dust container engages.
Cleaning the Housing, Nozzles and Extension Suction Tubes
• Clean the housing, the nozzles and the extension suction tubes if necessary using
a damp, soft cloth. Dry them with a soft cloth.
• Remove hair and fl uff from the nozzles at regular intervals.
Storage
Store the vacuum cleaner in a cool, dry place out of the reach of children and animals.

Troubleshooting

Should your device stop working properly at any time, exhibit signs of damage or require
a spare part, please contact the customer service department. For your own safety, do
not attempt to carry out repairs yourself. The following table contains tips on how you
can remedy small problems yourself.
Problem
The device does
not work.
The performance
is weak.
5. Reach into the dust container and press out the plastic
dust fi lter upwards.
6. Rinse the dust container and the plastic dust fi lter as re-
quired with clear, hot water.
CAUTION! Never wash the dust container and
the plastic dust fi lter in the dishwasher or in the
washing machine!
7. Allow the dust container and the plastic dust fi lter to dry
fully in the air.
CAUTION! Under no circumstances should you
use a hair dryer to dry the dust container or the
plastic dust fi lter. Never reinsert the container
and the fi lter if they are still damp!
Possible cause/solution/tips
• Is the plug not inserted in the mains socket correctly?
Insert the plug correctly.
• Is the plug socket defective? Try another plug socket.
• Check the fuse of your mains connection.
• Is the dust container too full? Empty the container.
• Are the dust fi lters heavily clogged? Clean them.
• Are the nozzles blocked? Clean the nozzles.
22