Cleaning And Storing The Device - Cleanmaxx Z 06439 Gebrauchsanleitung

Cleaning and Storing the Device

CAUTION!
• Always remove the mains plug from the plug socket before removing the dust container.
• Never immerse the motor housing in water or other liquids.
• Do not use any sharp or abrasive cleaning agents or cleaning pads to clean the
device. These could damage the surfaces.
Emptying the Dust Container
The dust container should be emptied at regular intervals to maintain good suction force.
You can look through the transparent housing to see how much dirt has accumulated inside.
A
B
Cleaning the Filter
A
B
2. Turn the dust container lid anticlockwise until you can pull it off.
4. Pull the catch for the bottom of the dust container downwards to open the dust con-
tainer in the manner described in the "Emptying the Dust Container" section.
21
1. Press down the release button for the dust container (A)
and tip the dust container slightly forwards (B) to release
it. Then remove the dust container upwards.
2. Hold the dust container over a dustbin or similar outlet.
Pull the catch for the bottom of the dust container down-
wards. The bottom of the dust container will fl ip open.
3. Then fl ip the bottom of the dust container shut again until
the catch correctly locks in place.
4. Insert the dust container back into the motor unit by fi rst
hooking the bottom part of the dust container onto the
motor unit and then pressing it against the motor unit until
the release button for the dust container engages.
1. Press down the release button for the dust container and
tip it slightly forwards to release the dust container. Then
remove it upwards.
3. Remove the fabric fi lter and tap it out or brush it down
using a soft brush if necessary.
CAUTION! Under no circumstances should you
rinse the fabric fi lter with water! The fi lter must
not become wet or be immersed in liquids!
EN