Installing And Connecting User Modules; Installing And Connecting Target Modules - G&D ControlCenter-Digital-80 Installationsanleitung

Installing and connecting user modules

The Fiber variants of the user modules use components with laser technology
which comply with laser class 1.
They meet the requirements in accordance to
and
U.S. CFR 1040.10
Mind the following instructions when dealing with laser beams:
 Avoid eye contact with invisible laser beam on page 2
 Always connect optical connections or cover them with protection caps on page 2
 Only use G&D certified transmission modules on page 2
NOTE: The installation of the modules is described in detail in the separate manual
Target Modules and User Modules
 Connect the console devices to the different user modules.
 Connect the Transmission interfaces of the individual user modules to one
Dynamic Port of a compatible IO card.

Installing and connecting target modules

The Fiber variants of the target modules use components with laser technology
which comply with laser class 1.
They meet the requirements in accordance to
and
U.S. CFR 1040.10
Mind the following instructions when dealing with laser beams:
 Avoid eye contact with invisible laser beam on page 2
 Always connect optical connections or cover them with protection caps on page 2
 Only use G&D certified transmission modules on page 2
NOTE: The installation of the modules is described in detail in the separate manual
Target Modules and User Modules
 Connect the target computers to the different target modules.
 Connect the Transmission interfaces of the individual target modules to one
Dynamic Port of a compatible IO card..
IMPORTANT: UC variants of target modules provide two Trans. interfaces to con-
nect a computer to two different KVM matrix systems. Connect only one of the tar-
get module's Trans. interfaces to this matrix switch!
.
1040.11
.
.
1040.11
.
EN 60825-1:2014 as well as
EN 60825-1:2014 as well as
G&D ControlCenter-Digital-80 · 11
Installation