Functions Of Components; In Addition To Controller And Switch Card, Operating The Matrix - G&D ControlCenter-Digital-80 Installationsanleitung

Modular design of the matrix switch

Functions of components

Controller and switch card are required to operate the matrix and are part of the
scope of delivery.
IMPORTANT:

In addition to controller and switch card, operating the matrix

requires one IO card (3)
back panel and at least one
The matrix switch components have the following tasks:
 The controller card (1)
tions.
 The switch card (4)
 The user modules and target modules of the KVM system are connected to the 16
ports of each
IO card (3)
 Each fan board (2
from outside into the device. The fans oftheFan OUT boards blow air out of the
casing.
A filter placed in front of the fans of the Fan IN board protects the components in
the casing against dust.
IMPORTANT: It is important to change the filters regularly. The time between
changing filters depends on how much the device is exposed to dust:
 strong dust exposure:
 regular dust exposure:
 light dust exposure:
Regularly check the condition of the filter. Clean lightly dusted filters by tapping
and/or light bursts of compressed air. Change the filter at the latest after a period
of six months.
 Up to three
power supply modules (6)
least two power supply modules, you can replace one of the modules during ope-
ration.
By distributing the load, the power is supplied evenly across all active power sup-
ply modules.
6 · G&D ControlCenter-Digital-80
, two fan boards (2)
power supply module(6)
administrates, monitors and controls all matrix switch func-
contains the central switching logic of the matrix switch.
.
and 5) provides two fans. The fans ofthe Fan IN boards suck air
1 month
3 months
6 months
supply power to the matrix switch. If you use at
on the front panel, two
.
fan boards (5) on the