Connecting the user modules
The user modules are connected to the matrix switch CATCenter NEO using a
category 5 (or better) twisted pair cable.
The recommended K-C7/LD-x cable enables the distance between the CATpro2
target module and the user module to be up to 300 metres (UCON-a: up to 100
metres). When other cables are used, the length depends on the quality of the ap-
plied cable.
Connection via the user module UCON
How to connect the user module UCON to the matrix switch:
Insert one end of the category 5 (or better) twisted pair cable into the
Transmission port of the user module.
Connect the other end of the twisted pair cable to any of the 16 Console ports of
the matrix switch CATCenter NEO.
Connect the monitor to the Monitor interface of the user module.
Connect keyboard and mouse to the user module.
Tip: Both input devices can be connected to the respective PS/2 or USB port.
A mixed connection (e. g. PS/2 mouse and USB keyboard) is possible.
Optional: If the additional TS Function has been purchased, connect the supplied
LED to the LED out interface.
Place this LED close to the monitor connected to this user module.
Installation Guide
G&D CATCenter NEO · 8