Filling The Blasting Medium Container; Mount The Collecting Bag For Sandblasting Material; Select And Fitting Attachments; Using The Compressed Air Sandblaster Gun - Parkside PDSP 1000 B2 Originalbetriebsanleitung

Filling the blasting medium container

CAUTION!
► Before you open the screw cap
blasting medium container
other settings, the connection to the com-
pressed air hose must be disconnected and
all pressure completely discharged.
■ Use only suitable blasting media
sandblasting work.
NOTE
► We recommend using a blasting medium
(ground blast furnace slag) with a grain size
of 0.2 mm–0.8 mm and which has been
shown not to cause silicosis.
■ Please ensure that the blasting medium
totally dry and not too coarse-grained.
NOTE
► The maximum grain size is 0.8 mm.
■ Open the screw cap
container by turning it anticlockwise.
■ Fill the required amount of blasting medium
into the blasting medium container
■ Ensure that you do not exceed the maximum
fill level for the container of 900 ml.
■ Afterwards, close the screw cap
blasting medium container
clockwise.
PDSP 1000 B2
on the
, or make any
for your
is
on the blasting medium
.
on the
by turning it
NOTE REGARDING THE BLASTING
MEDIUM GRAIN SIZE
► The larger/coarser the grain size of the blast-
ing medium used, the coarser the dirt that can
be removed using it. The supplied material,
on the other hand, is fine and thus more
suitable for the removal of items such as paint
or rust film. The fine material also causes less
damage to the surfaces being treated, meaning
a choice can be made regarding these.
For coarse rust, for example, it is best to use
a coarser-grained blasting medium which you
can buy online (see section "Importer") or in
any good specialist retailer. Please observe
the guidelines regarding maximum grain size.
Mount the collecting bag for sand-
blasting material
■ Use a screwdriver to attach the collecting bag
to the appliance with the supplied screw clip
.
Select and fitting attachments
■ Start by selecting the appropriate attachment
for the job at hand ( ,
■ Push the selected attachment firmly onto the jet
nozzle , ensuring that no air can escape from
the sides.
Using the compressed air sandblaster
gun
■ Carefully prepare the workpiece that is to be
blasted.
Clean it if necessary.
NOTE
► Layers of dust or fat will significantly impair
the results.
■ Carefully cover or mask everything that is not to
be blasted.
■ The distance between the attachment and the
surface being worked plays an important role
and should be kept as low as possible so that
the blasting medium
collecting bag .
, , ).
can be collected by the
GB │ MT │
35 ■