Herunterladen Inhalt Inhalt Diese Seite drucken

Switching On And Off; General Working Instructions; Adjusting The Working Angle; Using The Device As Grass Shears/Shrub Shears - Parkside PKGA 12 A1 Originalbetriebsanleitung

Vorschau ausblenden Andere Handbücher für PKGA 12 A1:
Inhaltsverzeichnis

Werbung

Switching on and off

1. If necessary, remove the blade guard
(9/11) before switching the device on.
2. To start the device, push the switch lock
(3) forwards and press the on/off switch
(5). Then release the switch lock (3).
The equipment runs at top speed.
3. In order to switch off, let go of the on/
off switch (5).
After switching the unit off,
the blades take a short time
to stop moving. Let the blades
come to a complete standstill.
Do not touch the blades or
slow them down before the
moving parts have come to a
standstill.
General working
instructions
Check the device before each use for
obvious defects such as loose, worn or
damaged parts.
Comply with the device's maintenance
and cleaning instructions.

Adjusting the working angle

Tilting the device handgrip:
The device handgrip (4) features three
angles of inclination:
1. Operate the unlocking mechanism (6)
and tilt the device handgrip (4) to the
desired angle.
2. Release the unlocking mechanism (6)
so that the device handgrip (4) locks
into place.
Rotating the device head:
The device head (1) features 7 positions:
1. Pull the unlocking mechanism (7) down-
wards and rotate the device head (1)
into the desired position.
2. Release the unlocking mechanism (7),
the device head (1) will lock into place.
Using the device as grass
shears/shrub shears
Ensure objects such as wire, metallic
parts, stones etc. do not enter the
blades while trimming. This can cau-
se damage to the cutting unit. If the
blades become jammed with solid ob-
jects, turn the device off immediately.
Ensure that the screws in the blade bar
are firmly in place.
Only use sharp blades to ensure good
trimming performance and to protect
the device and rechargeable battery.
Do not overload the device while wor-
king to such an extent that it comes to
a standstill.
Working using the grass shears
Grass is best cut when it is dry and not
too high.
Working using the shrub shears
Move the device in a steady forward
motion, or up and down in an arch-sha-
ped motion.
The double-sided blade bar enables trim-
ming in both directions, or via pendulum
movements from one side to the other.
GB
IE
27

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis