HomeMatic HM-LC-Dim1PWM-CV Installations- Und Bedienungsanleitung Seite 47

proceed as follows:
• Open the „WebUI" user interface in your browser.
• Click the „Teach-in devices" button on the right-hand
side of the screen.
• To activate teach-in mode, click „Teach-in HM
device" in the next window.
• Teach-in mode remains activated for 60 seconds.
An information box shows how much teach-in time
remains.
• Meanwhile, please activate the teach-in mode of the
dimming acutator to teach-in as well.
• Therefore, press and hold down the channel button
for at least 4 seconds. The device LED will flash
continuously to indicate that teach-in mode is active.
• After a short time, the newly taught-in device will
appear in the inbox of your software interface. The
button „Inbox (x new devices)" indicates how many
new devices have been taught-in successfully.
• If required, you can teach-in additional devices by
repeating the steps described above for each device.
• Now configure the newly taught-in devices in the
inbox as described in the next section.
47