Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ingress into the housing.
3
Function
The actuator controls connected LEDs by a power
consumption of up to 60 W after receiving radio
commands. Commands are send out by actuating
push buttons, remote operations or from a software
interface. In addition, it is possible to control actuators
with sensors that are taught-in. The sensors send (like
a push button) a command whenever an event occurs.
More information is provided in the instructions for the
respective sensor.
All data programmed is permanently saved on an
integrated memory - even in the event of a power
failure.
Using the push button for any purpose other
than that described in this operating manual
does not fall within the scope of intended use
and shall invalidate any warranty or liability.
This also applies to any conversion or
modification work. This device is intended for
private use only.
35
Werbung
Kapitel
Inhaltsverzeichnis
