Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

VOLTAGE TRACKING
The power supply can be set so that the voltage of O/P2 is automatically set to that of O/P1 and
tracks any changes.
INTERFACES (MX180TP only)
Full digital remote control facilities are available through the USB, RS232, LAN and GPIB
interfaces. Setting and readback resolutions are the same as for the Output and Meter
specifications respectively.
RS232:
USB:
LAN:
GPIB:
Remote Command
Processing Time:
GENERAL
AC Input:
Power Consumption:
Operating Range:
Storage Range:
Environmental:
Safety & EMC:
Size:
Weight:
Options:
16

Standardwerte

Bei Auslieferung ab Werk ist das Netzgerät wie folgt eingestellt:
Alle Ausgänge
Spannung
Strom
Bereich
OVP
OCP
Mittelwerte der Stromstärkemessung
Spannungstracking
Ausgang On/Off
Multi On/Off
Einstellungen auf Systemebene
Einschaltzustand
Warnton
Drehgeber
Die Standardwerte können über die Funktion "Reset to factory Defaults" wiederhergestellt
werden – siehe Abschnitt 9.7.
Standard 9-pin D-connector. Baud rate 9600.
Standard USB 2.0 hardware connection.
Ethernet 100/10base-T hardware connection. 1.4 LXI Core 2011.
Conforms with IEEE488.1 and IEEE488.2.
Typically 120ms (80ms min, 160ms max) between receiving the
command terminator for a step voltage change at the instrument and
the output voltage beginning to change.
115V – 240V AC ± 10%, 50/60Hz.
Installation Category II.
600VA max.
+5ºC to +40ºC, 20% to 80% RH.
−40ºC to + 70ºC.
Indoor use at altitudes up to 2000m, Pollution Degree 2.
Complies with EN61010-1 & EN3126-1.
For details, request the EU Declaration of Conformity for this
instrument via
http://www.aimtti.com/support
210 x 130 x 375mm (WxHxD) half rack width x 3U height.
5.8kg
19-inch rack kit for one or two units.
1 Volt
0,1 A
30V/6A (O/P1 and O/P2); 5.5V/3A (O/P3)
140V (O/P1), 70V (O/P2), 14V (O/P3)
22A (O/P1), 12A (O/P2), 3.5A (O/P3)
Aus (Level = Medium)
Aus
Aus
Alle Quick (synchron ein, synchron aus)
Einstellungen wie beim Abschalten, alle Ausgänge aus
Für Eingabefehler und Fehlerzustände aktiviert
Bei Aktivierung des CC Modus deaktiviert
Normal
Seite 46
(serial no. needed).

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Mx180tp

Inhaltsverzeichnis