Setup Location - Wellsystem RELAX_PLUS Original-Gebrauchsanweisung

Safety instructions and warnings
12/46
Assembly
DANGER!
Personal danger due to electric shock or burns!
– The assembly and electrical connection must comply
with the national regulations.
– Assembly, installation, upgrading or servicing of the
device may only be carried out by personnel specially
trained and authorized by JK-Global Service.
Information regarding the disassembly and assembly of the device is availa-
ble in the separate assembly instructions. These assembly instructions are
intended solely for use by the manufacturer's service personnel or by qualified
specialists authorized by the manufacturer.

Setup location

WARNING!
Overheating from inadequate cooling!
The device might be damaged!
– Maintain the minimum distances from the walls! Dimen-
sions are given on page 41.
– Do not change, obstruct or block the air inflow and
outflow to the device or make any unauthorized chang-
es to the device.
Salty air! Contaminated air!
Device damage due to corrosion of the housing and electri-
cal components.
– Do not install the device at swimming pools.
– Do not operate the device in locations with aggressive
environmental conditions (e.g. air containing chlorine)
Damage to device possible!
Where there are great differences in temperature between
the transport route and the installation site the device may
not be put into operation immediately after being set up.
– Wait at least 2 hours before connecting the device to
the power supply.
Environmental conditions
Optimum ambient temperature: Between 15 °C and 32 °C

Storage temperature: Between -15 °C and +60 °C (the well, pump and

the hoses must not contain any water)
Relative humidity: Between 30 % and 75 %

Air pressure: Between 700 hPa and 1060 hPa
