D) Connecting The Drive Battery To The Speed Controller; E) Switching On The Speed Controller; F) Controlling The Vehicle - Reely Desert Climber Bedienungsanleitung

d) Connecting the Drive Battery to the Speed Controller

First switch off the speed controller (switch position "OFF",
see labels next to the slider). The on/off switch (see arrow
in the figure on the right) is located at the bottom of the
vehicle.
To prevent sudden start-up of the wheels and
therefore uncontrolled starting of the model,
place the model vehicle on a suitable support
(or starting box), so that the wheels can turn
freely in case of an error.
Do not reach into the drive. Do not hold the
wheels.
Now connect the drive battery to the speed controller. Ensure correct polarity (red cable = plus/+, black cable =
minus/-). The tee plug connection between the drive battery and the speed controller is protected against polarity.

e) Switching on the Speed Controller

Release the throttle/brake lever (5) at the transmitter so that it sits in the neutral position.
Switch on the speed controller by moving the slider at the bottom of the vehicle (see figure in chapter 10. d) into the
"ON" position. The white LED lamps on the vehicle are activated.
Then wait for a few seconds (leave the throttle/brake lever on the transmitter in the neutral position; do not move it)
until the speed controller has completed its self-test.
Now check the drive and steering functions of the vehicle, e.g. by moving the steering wheel (6) to the left and right or
by carefully pushing the throttle/brake stick.
The LED (1) on the transmitter stops flashing when the transmitter has found the vehicle receiver). The
transmitter and the vehicle are then ready.

f) Controlling the Vehicle

Operate the throttle/braking lever for the drive function at the transmitter very cautiously and do not drive
too quickly at the beginning until you get used to the car's reactions. Do not make any quick and jerky
movements with the operating elements of the remote control.
If the vehicle tends to pull towards the left or the right, set the steering trim on the transmitter accordingly via the dial
switch "ST TRIM" (8).
If the vehicle moves only very slowly, turn the dial switch "TH D/R" (7) to the right to the stop.
The dial switch "TH D/R" makes the dual rate settings for the driving function. Putting it simply, you can use
the dial switch to set the maximum speed of the vehicle (at full deflection of the throttle/brake lever at the
transmitter).
Turn to the right clockwise = faster
Turn to the left counter clockwise = slower
46