Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

8. Charging Drive Battery

Observe chapters 6 and 7.
Only use the enclosed li-ion-drive battery or a spare battery of the same build in the vehicle. Never use any
other rechargeable batteries or batteries in the vehicle.
The drive battery is delivered uncharged and must be charged. Several complete discharge and charge
cycles are necessary before the drive battery delivers its maximum power.
Only charge the enclosed Li-Ion drive battery via the enclosed charger. Never use any other charger; this
may cause fire or explosion of the drive battery.
Only use the enclosed mains adapter to supply the charger with voltage/power.
Disconnect the drive battery from the speed controller/vehicle completely before charging and take it out of
the vehicle.
Charging of a partially discharged Li-Ion drive battery is not a problem. Previous discharge is not neces-
sary.
The drive battery heats up during charging/discharging (driving the vehicle). Wait until the drive battery has
reached room temperature before charging it. The same applies after the charging procedure. Do not use
the rechargeable battery in the vehicle until it has cooled down sufficiently after the charging process.
• First connect the round plug of the mains adapter to the corresponding round socket of the charger.
• Plug the mains adapter into a proper mains socket of the public mains (wall outlet). The power-LED of the charger
now needs to light up.
• Connect the 3-pin plug of the drive battery to the corresponding socket of the charger. Ensure proper alignment of
the plug and socket; only one position is correct.
• Charging commences; the charge LED lights up.
• When the charge LED goes out, the drive battery is fully charged. Charging may take several hours depending on
the charge condition.
• Disconnect the drive battery from the charger when the drive battery is fully charged.
• When the vehicle is not in operation (e.g. during winter storage), disconnect the drive battery from the speed con-
troller/vehicle. Keep the drive battery at a suitable site that is not accessible to children. Protect the rechargeable
battery contacts from short circuit since there is a danger of fire and explosion. The same applies at mechanical
damage to the rechargeable batteries or at high temperatures (e.g. near a heating or in direct sunlight).
• Pull the mains adapter from the mains socket when you no longer need the charger.
43

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

1527213

Inhaltsverzeichnis