Commissioning; Inserting Batteries/Rechargeable Batteries In The Transmitter; B) Taking The Transmitter Into Operation; Inserting The Drive Battery In The Vehicle - Reely Desert Climber Bedienungsanleitung

10. Commissioning

a) Inserting Batteries/Rechargeable Batteries in the Transmitter
Open the transmitter's battery compartment and insert either new batteries or fully charged rechargeable batteries.
Observe correct polarity (plus/+ and minus/-), see label on the battery compartment. Close the battery compartment
again.

b) Taking the Transmitter into Operation

Switch on the transmitter. The LED (1) flashes. Put the dial switch "ST TRIM" (8) to the middle position (trim for straight
operation), turn the dial switch "TH D/R" (7) clockwise to the right until the stop.
The "MODE" (3) button has no function in this vehicle (the same transmitter is also used for other vehicles).
c) Inserting the Drive Battery in the Vehicle
Attention!
The drive battery must not be connected to the speed controller yet. First switch on the transmitter, see
chapter 10. a) and 10. b).
Important!
This vehicle is exclusively suitable for use with a LiIon drive battery with 2 cells (rated voltage 7.4 V).
When using a drive battery with more cells, there is a danger of fire from overheating of the speed control-
ler. Apart from this, the vehicle's drive will be overloaded and damaged by this (e.g. differential). Loss of
guarantee/warranty!
Pull out the clip (A) and fold the battery bracket (B) up.
Insert the rechargeable battery into the battery compart-
ment of the vehicle.
Fasten the rechargeable battery with the battery bracket
(B) and insert the clip (A) again.
45