Scheppach WOODSTER TMR452-98H-RD Originalbetriebsanleitung Seite 53

1. Incorrect start sequence
2. Choke setting incorrect
3. Throttle in wrong position
4. Spark plug is defective
5. Fuel tank is empty
6. poor fuel, storage without emptying
Engine does not run
7. spark plug fouled (carbon residue on
8. The spark plug is wet from the petrol
9. Engine defective
1. Cooling fins are dirty
2. Engine oil level too low
Engine gets very hot
3. V-belt worn out
1. Drive disengaged
Product does not run
2. V-belt (transmission) worn or dam-
Engine runs unsteadily
1. Air filter dirty
2. Spark plug dirty
Lawn turns yellow, une-
1. Mowing blade is not sharp
ven mowing results
2. Cutting height is too low
1. Cutting height is too low
2. Mowing blade worn out
3. Collection basket is clogged
The discharge of grass
4. Ejector chute blocked
clippings is unclean
5. Grass too wet
6. Driving speed too high
Engine output drops
1. The driving speed in relation to the
during mowing
1. The brake is no longer set correctly
Braking power insuffi-
cient
the fuel tank, incorrect petrol type
the electrodes), electrode distance
too large
(engine flooded)
aged
cutting height is too high
www.scheppach.com
1. Check start process
2. Check choke setting
3. Check setting
4. Replace spark plug
5. Refill with fuel
6. Empty the fuel tank and carburettor. Fill with
fresh petrol
7. Clean the plug, check the heat value of the
plug, replace the spark plug as required, set
to 0.6 - 0.7 mm
8. Dry the spark plug and insert it again
9. Contact authorised customer service
1. Clean the cooling fins
2. Check fill level of engine oil and top up
engine oil
3. Contact the specialist merchant/customer
service
1. Engage the drive
2. Contact the specialist merchant/customer
service
1. Clean the air filter
2. Clean the spark plug
1. Sharpen the mowing blade
2. Set the correct height
1. Set height
2. Contact the specialist merchant/customer
service
3. Empty the collection basket or remove the
blockage
4. Clean the ejector chute
5. Mow during dry weather
6. Adapt speed
1. Reduce the driving speed and increase the
cutting height
1. Contact the specialist merchant/customer
service
GB | 53