Technical Data - Scheppach Basa4 Originalbetriebsanleitung

• Observe the instructions of the employers' liability
insurance association (VBG 7).
• Set the adjustable guards such that they are as
close as possible to the workpiece.
m Attention! Secure long workpieces against tipping at
the end of the cutting process. (e.g. roller stand, etc.)
• Contact the service centre immediately if you notice
any malfunctions or faults with the product, including
the guards and tools.
• The saw band guard (4) must be in the lower position
during transport of the saw.
• Protective covers must not be used for transport or
improper operation of the machine.
• Deformed or damaged saw bands may not be used.
• Replace a worn table inlay.
• Never operate the machine when the door protect-
ing the saw band or the guard is open.
• Make sure that the choice of saw band and speed is
suitable for the material to be cut.
• Do not start cleaning the saw band until it has come
to a complete stop.
• Use a push stick when making straight cuts in small
workpieces against the parallel stop.
• Wear gloves when handling the saw band and rough
materials!
• For mitre cuts with an inclined saw table, the parallel
stop should be placed on the lower part of the saw table.
• Never use guards for lifting or transport.
• Be sure to use and properly adjust the saw band guards.
• Keep your hands at a safe distance from the band
saw blade. Use a push stick for narrow cuts.
• Store the push stick on the holder provided for it on
the machine so that you can reach it from your nor-
mal working position and always have it to hand.
• In the normal working position, the operator is in
front of the machine.
• Warning: The product can create ignition sources
during operation!

6. Technical data

Engine
230-240 V
1.5kW (S1)
Power 1.8 kW
(S6 40%)
Idle speed
Saw band
length
34 | GB
Three-phase
AC
current
400 V 3 phase
1.5kW (S1)
1.8 kW
(S6 40%)
1480 rpm
2895 mm
www.scheppach.com
Saw band width
Max. band saw
blade width
Band saw blade
speed
Cut height
Swing
Table size
Table inclinable
Max. workpiece
size
Weight
Subject to technical changes!
*Operating mode S1 (continuous operation)
The machine can be operated continuously with the
specified power.
* Operating mode S6 40%:
Continuous duty with intermittent loading (operating
time 10 min.)
In order avoid impermissible overheating of the motor,
the motor should be driven for only 40% of the operat-
ing time with the stipulated nominal power and must
then continue to run with no load for the remaining 60%
of the operating time.
The workpiece must have a minimum height of 3 mm
and a minimum width of 10 mm.
Noise data
Measurement per ISO 19085-16:2021, Annex F, using:
ISO 3744:2010 for the noise power: ISO 3746:2010 with
accuracy class 3 for the emission sound pressure: ISO
11202:2010 with accuracy class 3.
Operating conditions during the measurements: ISO
19085-16:2021, F.5.
If the specified emission values are to be checked, the
measurements must be carried out using the same
procedure and under the same operating and installa-
tion conditions as those specified.
WARNING: The specified sound emission values are
only valid if the same operating and installation con-
ditions apply.
6-25 mm
25 mm
700-1000 m/min
250 mm
375 mm
400 x 548 mm
-17°/+45°
375 x 250 mm
98 kg