Scheppach BASA4 Originalbetriebsanleitung Seite 30

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new product brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this product assumes no liability
for damage to the product or caused by the product
arising from:
• Improper handling
• Failure to comply with the operating manual
• Repairs carried out by third parties, unauthorised
specialists
• Installing and replacing non-original spare parts
• Improper use
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
57113 / VDE 0113 not being observed
Note:
The operating manual is part of this product. It includes
important instructions for the safe, proper and econom-
ic operation of the product, for avoiding danger, for min-
imising repair costs and downtimes and for increasing
the reliability and extending the service life of the prod-
uct. In addition to the safety instructions in this operat-
ing manual, you must also observe the regulations ap-
plicable to the operation of the product in your country.
Familiarise yourself with all operating and safety in-
structions before using the product. Only operate the
product as described and for the specified areas of ap-
plication. Keep the operating manual in a good place
and hand over all documents when passing the product
on to third parties.
2. Device description, Fig. 1-20
1. Housing door
2. Door lock (2.1 top/2.2 bottom)
3. Band saw blade guard
4. Saw band guide
5. Rip fence
6. Saw table
7. Main frame
30 | GB
8. On/off switch
9. Adjusting knob for saw belt tension
10. Adjusting knob for top band wheel
11. Engine
12. Suction port
13. Adjustment handle for the saw band guard
14. Table inlay
15. Quick clamp lever, saw belt tension
16. quick clamp lever, belt tension
17. Machine stand
18. Transport wheels
19. Transport handle
20. quick clamp lever, angle adjustment
21. Adjusting knob, angle setting, saw table
22. Adjustment screw, angle adjustment
23. Electrical power connection
24. Tailstock holder
25. Lock nut
26. Thrust bearing mount
27. top and bottom guide rollers
28. Clamping lever, rip fence
29. Push stick
30. Mitre gauge
31. Guide rail
3. Scope of delivery
• Open the packaging and carefully remove the de-
vice.
• Remove the packaging material, as well as the
packaging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for trans-
port damage.
• If possible, keep the packaging until the expiry of
the warranty period.
Attention! The device and the packaging are not chil-
dren's toys! Do not let children play with plastic bags,
films or small parts! There is a danger of choking or
suffocating!
• Band saw
• Saw table
• Push stick
• Rip fence
• Fixing material
• Hexagon spanner - size 10/ 13
• Hexagon spanner - size 3/4
• Original Operating Manual
• Suction port
www.scheppach.com