Scheppach BASA4 Originalbetriebsanleitung Seite 42

- Further supplementary take-back conditions of
the manufacturers and distributors can be ob-
tained from the respective customer service.
• If the manufacturer delivers a new electrical device
to a private household, the manufacturer can ar-
range for the free collection of the old electrical de-
vice upon request from the end user. Please contact
the manufacturer's customer service for this.
15. Troubleshooting
Fault Possible cause
Motor does not work • Motor, cable or plug defective, fuses
• Open housing cover (limit switch)
The engine runs Voltage too low, coils damaged, capac-
slowly and does not itor burnt
reach the operating
speed.
Motor makes exces- Coils damaged, motor defective
sive noise
The motor does not Circuits in the network are overloaded
reach its full power. (lamps, other motors, etc.)
Motor overheats Overloading of the motor, insufficient
easily. cooling of the motor
Saw cut is rough or Saw blade dull, tooth shape not appro-
wavy priate for the material thickness
Workpiece pulls Excessive cutting pressure and/or saw
away and/or splin- blade not suitable for use
ters
Saw band drifting • Guide incorrectly adjusted
• Incorrect saw band
Burn marks on the • Saw band blunt
wood when working • Incorrect saw band
Saw band jams • Saw band blunt
when working • Saw band resinous
• Guide incorrectly adjusted
42 | GB
burnt
www.scheppach.com
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal of
waste electrical and electronic equipment.
Remedy
• Arrange for inspection of the machine by a
specialist. Never repair the motor yourself.
Danger! Check fuses and replace as neces-
sary
• Close housing cover precisely
Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a special-
ist. Arrange for replacement of the capacitor by
a specialist
Arrange for inspection of the motor by a spe-
cialist
Do not use any other equipment or engines on
the same circuit
Avoid overloading the motor while cutting,
remove dust from the motor in order to ensure
optimal cooling of the motor
Resharpen saw blade and/or use suitable saw
blade
Insert suitable saw blade
• Adjust the saw band guide according to the
operating manual
• Select saw band according to the operating
manual
• Replace saw band
• Select saw band according to the operating
manual
• Replace saw band
• Clean saw band
• Adjust the saw band guide according to the
operating manual