Cleaning And Storing The Device And Cuff; Technical Specifications - Beurer BM 47 Gebrauchsanweisung

ues are accorded second priority under the standard IEC
60601-1-8.
The technical alarm is a non-locking alarm and must not be
reset. The signal shown on the display will disappear auto-
matically after about 8 seconds.

9. Cleaning and storing the device and cuff

• Clean the device and cuff carefully using a slightly damp
cloth only.
• Do not use any cleaning agents or solvents.
• Under no circumstances hold the device and cuff under
water, as this can cause liquid to enter and damage the
device and cuff.
• If you store the device and cuff, do not place heavy ob-
jects on the device and cuff. Remove the batteries. The
cuff line should not be bent sharply.

10. Technical specifications

Model no. BM 47
Measurement Oscillometric, non-invasive blood
method pressure measurement on the upper
arm
Measurement range Cuff pressure 0-300 mmHg,
systolic 60-260 mmHg,
diastolic 40-199 mmHg,
Pulse 40-180 beats/minute
Display accuracy
Measurement inac-
curacy
Memory
Dimensions
Weight
Cuff size
Permissible operating
conditions
Permissible storage
conditions
Power supply
Battery life
Classification
28
Systolic ± 3 mmHg,
diastolic ± 3 mmHg,
pulse ± 5 % of the value shown
Max. permissible standard deviation
according to clinical testing:
systolic 8 mmHg /diastolic 8 mmHg
4 x 30 memory spaces
L 134 mm x W 102 mm x H 52,5 mm
Approximately 280g (without batter-
ies and cuff)
22 to 35 cm
+10 °C to +40 °C, ≤ 85 % relative air
humidity (non-condensing)
-20 °C to +50 °C, ≤ 85 % relative air
humidity, 800-1050 hPa ambient
pressure
4 x 1,5 V AA batteries
For approx. 500 measurements,
depending on the blood pressure
level and/or pump pressure
Internal supply, IPX0, no AP or
APG, continuous operation, type BF
applied part