Commissioning; A) Inserting Batteries In The Outdoor Sensor; B) Inserting The Batteries Into The Weather Station - Conrad WS 1173 Bedienungsanleitung

9. Commissioning

a) Inserting Batteries in the Outdoor Sensor

• Open the battery compartment on the back of the outdoor sensor by turning out the
attachment screw of the battery compartment lid.
• Insert two type AAA/Micro batteries in the battery compartment in the correct polarity
(observe plus/+ and minus/-).
• Close the battery compartment lid again.

b) Inserting the Batteries into the Weather Station

• Open the battery compartment on the rear of the weather station and insert 3 type AA/mignon
batteries into with correct polarity (observe plus/+ and minus/-).
• Close the battery compartment again.
• The weather station display briefly shows all display segments and the display lighting will
be activated briefly.
Then the weather station searches for the outdoor sensor and the display shows
" ".

The sensor search takes about 3 minutes; do not move the weather station and the
outdoor sensor during this period and do not push any button.
• After completion of the sensor search, the weather station will start a reception attempt for
the DCF signal; the radio tower symbol " " flashes in the lower side of the display.

The search for the DCF signal and assessment of the signal may take up to 10
minutes; do not move the weather station during this time and do not push any button.
If no DCF signal is recognised within 1 minute, the weather station interrupts the DCF
search and will restart it after 2 hours.
If you want to restart the DCF signal search manually, remove the batteries from the
weather station. Wait for 10 seconds and re-insert them.
40