Deleting The Value Memory For The Wind Speed; Turning The Wind Speed Alarm On/Off; Setting The Wind Speed Alarm - Conrad DV928 Bedienungsanleitung

 Deleting the value memory for the wind speed
Keep the button "MEMORY" (17) depressed approx. 3 seconds to delete the value memories.
 Turning the wind speed alarm on/off
You can activate an alarm for the wind speed and an alarm for wind gusts. When the set wind speed is exceeded,
an alarm is issued (stop this by pressing the button "ALARM/CHART").
• Briefly press the button "ALARM/CHART" (10) to switch between the alarm for the wind speed (display "ALARM
HI"), the alarm for wind gusts (display "GUST" + "ALARM HI") and the normal display.
If "ALARM HI" or "GUST" + "ALARM HI" is displayed, you can activate or deactivate the corresponding wind speed
alarm by briefly pressing the button " " (16) or " " (18) on the rear.

When the alarm is deactivated, the display shows "OFF"; when it is activated, the respective value.
 Setting the wind speed alarm
• First press the button "ALARM/CHART" (10) once or twice to select the normal wind speed alarm (display "ALARM
HI") or the wind gust alarm (display "GUST" + "ALARM HI"). Then briefly press the button " " (16) or " " (18)
on the rear to activate the alarm (if applicable).
• Now keep the button "ALARM/CHART" (10) depressed until the wind speed value blinks.
• You can change the wind speed value with the buttons " " (16) or " " (18) on the rear (keep the respective button
depressed longer for quick adjustment).
• Save the setting by briefly pressing the button "ALARM/CHART" (10).
90