Loading Label Roll In Tear-Off Mode - Carl Valentin DUOPRINT Kurzanleitung

DuoPrint

Loading Label Roll in Tear-off Mode


Open the printer cover.

Open printheads (A) by turning the red pressure levers (B) anticlockwise.

Remove the optional outside label mounting plate from the unwinder.

Load the label roll with inner winding onto the unwinding roll.

Attach again the label mounting plate.

Lead the label material below the return pulley (D) and the printheads (A).
Pay attention that the label runs through the photocells (F).

In order to move the printheads (A) down, turn the red pressure levers (B) in clockwise direction until they lock.

In front of the first printhead you can see the tear off edge (G) from which you can rip off labels to the bottom.

Enter the offset value in the menu Print settings/Tear off.

Adjust the adjusting ring (E) onto the return pulley (D) and the label guiding (C) to the width of material.

Close the printer cover.
86 English