Load Label Roll In Tear-Off Mode - Carl Valentin SPECTRA II Schnellreferenzhandbuch

Spectra II

Load Label Roll in Tear-off Mode

I
H
G
F
E
•
Open the printer cover.
•
Open the printhead (G) by turning the pressure lever (H) anticlockwise.
Spectra 216: Pull the centring plate (I) outwardly.
•
Remove the outside label mounting plate (A).
•
Load the label roll with inner winding onto the unwinding roll (B) and attach again the label mounting plate (A).
•
Lead the label material below the label guiding (D).
Pay attention that the label runs through the photocell (E).
Spectra 216: Lift the centring plate (I) again upwards.
•
In order to move the printhead (G) down, turn the pressure lever (H) in clockwise direction until it locks.
•
The tear off edge (F) is visible in front of the printhead.
•
Enter the offset value in the menu Print settings/Tear off.
•
Adjust the limit stops (C) of the label guiding to the width of material.
•
Close the printer cover.
62 English
A
B
C
D