Loading Label Roll In Tear-Off Mode - Carl Valentin Spectra 107/12 Schnellreferenzanleitung

Loading label roll in tear-off mode


Open the printer cover.

Open printhead (A) by turning the red pressure lever (B) anticlockwise.
Spectra 216: Pull centring plate (K) outwardly.

Remove the outside label mounting plate (C).

Load the label roll with inner winding onto the unwinding roll (D) and attach again the label mounting plate.

Lead the label material below the label guiding (E).
Pay attention that the label runs through the photocell (F).
Spectra 216: Lift centring plate (K) again upwards.

In order to move the printhead (A) down, turn the red pressure lever (B) in clockwise direction until it locks.

In front of the printhead you can see the tear off (G) from which you can rip off labels to the bottom.

Enter the offset value in the menu 'Print settings/Tear off'.

Adjust the adjusting rings (H) of the label guiding to the width of material.

Close the printer cover.
All manuals and user guides at all-guides.com
English
Spectra
85