Load Label Roll In Tear-Off Mode - Carl Valentin Spectra 107/12 Kurzanleitung Und Hinweise Zur Produktsicherheit

Load Label Roll in Tear-off Mode

•
Open the printer cover.
•
Open the printhead (A) by turning the red pressure lever (B) anticlockwise.
Spectra 216: Pull the centring plate (K) outwardly.
•
Remove the outside label mounting plate (C).
•
Load the label roll with inner winding onto the unwinding roll (D) and attach again the label mounting plate.
•
Lead the label material below the label guiding (E).
Pay attention that the label runs through the photocell (F).
Spectra 216: Lift the centring plate (K) again upwards.
•
In order to move the printhead (A) down, turn the red pressure lever (B) in clockwise direction until it locks.
•
The tear off edge (G) is visible in front of the printhead.
•
Enter the offset value in the menu 'Print settings/Tear off'.
•
Adjust the adjusting rings (H) of the label guiding to the width of material.
•
Close the printer cover.
English
Spectra
85