Herunterladen Inhalt Inhalt Diese Seite drucken

Loading Label Roll In Tear-Off Mode - Carl Valentin SPECTRA II Kurzanleitung

Vorschau ausblenden Andere Handbücher für SPECTRA II:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Spectra II

Loading label roll in tear-off mode

H
G
F
E
Open the printer cover.
Open printhead (G) by turning the pressure lever (H) anticlockwise.
Remove the outside label mounting plate (A).
Load the label roll with inner winding onto the unwinding roll (B) and attach again the label mounting plate (A).
Lead the label material below the label guiding (D).
Pay attention that the label runs through the photocell (E).
In order to move the printhead (G) down, turn the pressure lever (H) in clockwise direction until it locks.
In front of the printhead you can see the tear off (F) from which you can rip off labels to the bottom.
Enter the offset value in the menu Print settings/Tear off.
Adjust the limit stops (C) of the label guiding to the width of material.
Close the printer cover.
62
English
A
B
C
D

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis