Packaging - Abicor Binzel Istm Mini Bedienungsanleitung

iSTM mini
DANGER
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
1 Disconnect the cable assembly from the wire feeder.
2 Pull out the cable assembly.
3 Disconnect the torch neck and remove it.
 6.3 Attaching the ABIROB
 6.4 Attaching the ABIROB
 6.5 Attaching the wire guide on page EN-20
4 Disassemble the iSTM mini from the robot.
 6.2 Maintenance position of the robot on page EN-13
12 Disposal
When disposing of the system, local regulations, laws, provisions, standards and guidelines must be observed. To correctly
dispose of the product, it must first be disassembled.
 11 Disassembly on page EN-26
12.1 Materials
This product consists for the most part of plastics, steel and nonferrous metals. Steel and nonferrous metals can be molten in
steel and iron works and are thus almost infinitely recyclable. The plastic materials used are labeled in preparation for their
sorting and separation for later recycling.
12.2 Consumables
Oil, greases and cleaning agents must not contaminate the ground or enter the sewage system. These substances must be
stored, transported and disposed of in suitable containers. Observe the relevant local regulations and disposal instructions
in the safety data sheets specified by the manufacturer of the consumables. Contaminated cleaning tools (brushes, rags, etc.)
must also be disposed of in accordance with the information provided by the consumables' manufacturer.

12.3 Packaging

ABICOR BINZEL has reduced the transport packaging to the necessary minimum. The ability to recycle packaging
materials is always considered during their selection.
BAL.0523.0 • 2019-10-17
®
G torch neck on page EN-18
®
W torch neck on page EN-19
12 Disposal
EN - 27