MSW RCGK-KEG1 Benutzerhandbuch Seite 23

However, 4mm ID lines can be difficult to fit over barb fittings (e.g., keg couplers or
ball lock disconnects).
How to Fit 4mm ID Beer Line Over Barb Fittings:
1. Soften the Beer Line:
o
2. Stretch the Line:
o
o
Minimum Clearances Around the Kegerator
The kegerator has radiators located on the left and right‐hand walls.
•
These radiators must be well-ventilated to allow heat to escape.
Ensure a minimum clearance of 100mm (4 inches) on both sides of
•
the kegerator for proper ventilation.
Inadequate ventilation may lead to:
•
o
o
o
Avoid placing the kegerator in corners or against two walls where
•
proper ventilation cannot occur, as this will limit the unit's ability to
cool efficiently and may cause overheating.
Submerge the line in boiling water for 30 seconds to soften it.
Use needle‐nose pliers to stretch the internal diameter of the beer
line.
Push the softened beer line onto the needle-nose pliers, then open
the plier handles to further stretch the line.
Void warranty.
Increased electrical consumption.
Premature failure of the kegerator.
EN